|
Car |
Manufacturer |
Ballast |
Magnet |
Category |
|
All « Formula 1 » and « Indy » manufact. after 1st Jan 2001 |
Hornby Hobbies (Scalextric) |
YES |
NO |
F1 or Indy |
Weight |
Free. Free ballast to glue on the chassis and to be kept within the confines of the body shell. |
Chassis and body |
No modification allowed except the cutting for the wires of the guide (see Guide) At the beginning of each heat, all parts (except mirrors and camera) must be in place. All the screws must permanently be in place but not obligatorily completely tightened. |
Front axle and hubs |
Origin. Maximum width with tyres : 65mm |
|
Rear axle and hubs |
Origin. Maximum width with tyres : 65mm |
Bearings |
Origin (white plastic). Rear bearings can be glued into the chassis. |
Motor |
Scalextric origin as delivered within the Formula 1 and the Indy cars. Max. speed measured at the rear axle with 12VDC : 7800 rpm. The motor may be glued to the chassis or fixed by a tape. |
Front tyres |
1/32° tyres made by a manufacturer of 1/32° cars. The tyres may be reduced in diameter but can not be glued and can not be varnished and must cover the entire hubs. |
Rear tyres |
Origin. Maximum width : 14mm. Minimum diameter : 19mm.The tyres may be trued but can not be glued.The tyres can not glue and can not let traces on the track. |
|
Pinion |
Origin, 9 teeth in white plastic. |
|
Crown |
Origin, 27 teeth in plastic |
|
Guide |
Free. The original spring can be removed. The easy-fit guide may be equipped with wires or be replaced by a wired type. If necessary, the body can be slightly cut above the guide to allow to pass the wires of the guide. The front of the guide may be cut in oblique and the length of the guide may be sanded. |
Braids + wires |
Free. |
Notes
|
§ As far as possible, parts from the F1 and Indy cars can be mixed. § The inspections and tests are made during or after the competition. The cars must always be legal. The motor tests are made with a Kelvin Light testing bench. § Only products and clothes provided by the organisation are allowed as well during the qualifications as during the competition. § Measure of the width of the axles : must pass freely (without friction) in a calibre of 65mm. § Any modifications not mentioned in this technical spec. are illegal. |